Linx-technologies EVM-GPS-F4 Instrukcja Użytkownika Strona 4

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 7
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 3
– –
– –
2 3
Ordering Information
Ordering Information
Part Number Description
EVM-GPS-F4 F4 Series Evaluation Module
RXM-GPS-F4 F4 Series GPS Receiver Module
Figure 2: Ordering Information
ElectricalSpecications
Ordering Information
Parameter Designation Min. Typ. Max. Units Notes
POWER SUPPLY
Supply Voltage V
CC
1.71 1.8 1.89 VDC
Input Pin Voltage 3.6 VDC
Output Pin Voltage 1.8 VDC
Supply Current I
CC
Peak 130 mA 1
Acquisition 46 mA 1
Tracking 27.5 mA 1
Hibernate 20 µA 2
Ready-to-Start 9 µA 2
ANTENNA PORT
RF Input Impedance R
IN
50 Ω
ENVIRONMENTAL
Operating Temperature Range –30 +85 °C
Storage Temperature Range –40 +85 °C
Figure 3: Electrical Specifications
Notes:
1. V
CC
= 1.8V
2. Initial state after power us applied
Warning: This product incorporates numerous static-sensitive
components. Always wear an ESD wrist strap and observe proper ESD
handling procedures when working with this device. Failure to observe
this precaution may result in module damage or failure.
Pin Assignments
GND
NC
NC
VCC
NC
VBACKUP
GPIOC
GPIOB
GPIOA
GND
GND
GPIOD
GPIOE
TXM
RXM
1PPS
RESET
RFPWRUP
ON_OFF
GND
Figure 4: EVM-GPS-F4 Pin Assignments
Pin Descriptions
Pin Descriptions
Pin Number Name I/O Description
1 GPIOD I/O General Purpose I/O. 3.6V tolerant.
2 GPIOE I/O General Purpose I/O. 3.6V tolerant.
3 1PPS O 1 Pulse Per Second. 1.8V level.
4 TX O Serial output (default NMEA)
5 RX I Serial input (default NMEA). 3.6V tolerant.
6 GPIOC I/O General Purpose I/O. 3.6V tolerant.
7, 11 P1, P2 I Pull to 1.8V VCC through 2.2k resistors.
8 /RESET I
Reset Input. Active low with an internal pull-up.
Internal reset is preferred; external reset will clear all
RAM. 3.6V tolerant.
9 RFPWRUP O Power State Indicator
10 ON_OFF I
Power Control Pin. Internal 10k pull-down resistor.
3.6V tolerant.
12 VCC P Supply Voltage
13 G1 I Pull to GND through a 100k resistor.
14 GPIOA I/O General Purpose I/O. 3.6V tolerant.
15 GPIOB I/O General Purpose I/O. 3.6V tolerant.
16, 17 NC No electrical connection.
18, 20, 21, 22 GND P Ground
19 RFIN I GPS RF signal input
Figure 5: F4 Series GPS Receiver Pin Descriptions
Przeglądanie stron 3
1 2 3 4 5 6 7

Komentarze do niniejszej Instrukcji

Brak uwag